iDirect iQ LTE Series, Инструкция по установке, поддержке и обслуживанию

Страница: 57 / 70

Installation, Support, and Maintenance Guide 43
iQ LTE Satellite Router
Ethernet Port Pinouts
Figure C-5. Compression fitting F-Type Weatherproof Plug and Tool
10. Inspect and ensure that the copper center conductor only protrudes 1/8 inch (3.2 mm)
nominally beyond the rim of the F-connector. Trim if necessary.
C.2 Ethernet Port Pinouts
The Ethernet cable included in the order is typically a straight through cable typically used
for connection to a PC. The X7 Router is capable of Universal Cable Recognition or auto-MIDX
(auto-sensing) and will connect to a PC with the straight through Ethernet cable for using the
user interface.
LAN 1 port is the recommended port to connect the Ethernet cable to the Ethernet port on
the PC running the user interface.
Either crossover or straight through cables may be used with the X7 Router. It is not necessary
for the PC to auto-sense. Details of the X7 Router LAN/Ethernet port pinouts are described in
Section C.2.1 and Section C.2.2 defines straight through and crossover cables.
C.2.1 Ethernet Port Pinouts
Table C-2 lists the pinouts for the Ethernet ports (labeled LAN 1-2) of the X7 Router and the
pinout order is shown in Figure C-6 .
CAUTION: The center conductor length must be a minimum of 1/16 inch (1.6 mm)
to a maximum of 1/8 inch (3.2 mm) protrusion beyond the rim of the F type
connector. It must be straight and cylindrical without any burrs at the end. Failure
to follow this technique could result in damage to the satellite router, BUC, LNB
connector and/or possible intermittent service.
Table C-2. Ethernet Port Pinouts
RJ-45 Pin Description
1 Tx+
2 Rx+