Idex Knight DoseTech DMS, Инструкция по эксплуатации

Страница: 2 / 26

Page 2 0901048 Rev. C
Table of Contents
Introduction 2
System Control Panel 2
Specifications 3
Accessory Kit Checklist 3
Installation Procedures 4
Programming 6
Operations 11
Troubleshooting 12
Squeeze Tube Replacement 14
Replacement Parts 15
Parts Diagram 16
Wiring Diagram 17
EC - Declaration of Conformity 18
Mounting Template 22
Warranty Information 24
Knight Locations 24
Introduction
The DoseTech DMS detergent management system is a dispensing system used to transfer precise amounts of pre-soak chemicals into
a pre-wash sink. This chemical dosing system uses an electronically controlled peristaltic pump to dispense detergent. Multiple dosing
levels can be programmed to meet specific soil conditions for full and half sink levels providing optimal cleaning results prior to
automated decontamination steps. The system is comprised of main control/pump unit, water temperature monitor, chemical supply
line with weight and filter, chemical discharge line with check valve and attaching hardware. System is not for use in potentially
explosive environments.
Safety Symbols
Listed below are explanations of the safety symbols that appear either on the unit, in the instruction manual, or both. Please
familiarize yourself with the meaning of each symbol.
GENERAL CAUTION:
This symbol indicates a general safety caution.
SHOCK HAZARD: This symbol indicates that hazardous voltages are inside the enclosure.
READ MANUAL: This symbol indicates to read the manual for important instructions and procedures related to safety.
Safety Precautions
CAUTION: Wear protective clothing and eye wear whenever operating this system.
CAUTION: Wear protective clothing and eye wear when dispensing chemicals. Observe safe handling instructions (MSDS)
provided on chemical container or as supplied by chemical manufacturer.
CAUTION: To avoid severe or fatal shock, physical injury, always disconnect main power when servicing the unit.
• System is for indoor use only
• Do not submerge or place in direct path of spray/moisture
• System operates on safe 24 VDC power
• Only approved, factory authorized technicians to service unit