Idex Knight DoseTech DMS, Инструкция по эксплуатации

Страница: 5 / 26

0901048 Rev. C Page 5
11. Route the dispenser discharge tube and temperature probe to the back of the sink
where it will be mounted just above the bottom (1-3”), depending on the total
volume of the sink fill. Trim the excess tubing from the dispenser discharge tube
once you have verified the length. Attach the check valve to the end of the
dispenser discharge tube. Make sure that the arrow points in the direction of the
flow. Use the vinyl suction cup and cable ties to secure the discharge tube and
temperature probe to the inside of the sink. See Fig. 7. Use additional cable ties to
secure the dispenser discharge tube to the temperature probe to keep them
together as they go up to the dispenser.
12. Route the power supply cable to the outlet and secure with the cable ties. If the
detergent suction tube and power supply are located on the same side, secure
them together for a cleaner installation.
13. If mounting the remote control away from the dispenser, you will need to
loosen the strain reliefs on the bottom of the dispenser, open the control cover,
cut the zip tie, and pull the cables to the length needed (up to 12 feet). Do not
pull on the remote control unit to pull the cables out. Roll up the left over cables
and place them back into the dispenser. Close the control cover and tighten the
strain reliefs. See Fig. 8.
14. Measure the distance between the key holes on the remote wall bracket and
pre-drill the holes for the anchors in the wall. Insert the anchors. Attach the
remote wall bracket with the screws to the anchors. Mount the remote to the
remote wall bracket by sliding it down onto the bracket until it locks into place.
See Fig. 9.
15.
If you will be using the sink top mounting kit, rather than wall mounting the
dispenser, attach the four hex stand off screws to the bottom of the dispenser.
Attach the stand base to the hex stand off screws with the four pan head screws.
See Fig 10.
16.
If you will be using the foot pedal control (Fig. 11) for hands free dosing, loosen
the strain relief on the bottom of the dispenser, insert the wires from the foot
pedal control, remove the remote and open the control cover. Attach the white
wire to the REMOTE START terminal on the barrier strip and the black wire to
the GND terminal on the barrier strip. See Fig. 12. Tighten the strain relief, close
the control cover and attach the remote.
Fig.11 Fig.12
Fig.10
Fig.9
Fig.8
Fig.7
Fig.6
White wire
connection
Black wire
connection