Idex Knight DoseTech DMS, Инструкция по эксплуатации, Страница: 9 / 26

0901048 Rev. C Page 9
Description of Screen Display
21.
To calibrate the pump, place the dispensing tube into a 100-200 milliliter graduated cylinder and press the UP
button. The pump will stop on its own after dispensing approximately 100 milliliters of detergent and the display
will automatically change to the Entered Captured screen.
22.
To enter the volume captured by the graduated cylinder, use the SCROLL button to scroll between digits and the UP
and DOWN buttons to cycle between 0-9.
Press ENTER to advance to the next screen.
23.
The flow rate for the pump is displayed.
Press ENTER to advance to the next screen.
24.
To check for proper calibration, repeat the pump calibration steps. The target calibration volume is 100 mls +/-- 3 mls.
Once you are satisfied with the calibration of the pump, press ENTER to advance to the next screen.
25.
To set a temperature range, use the SCROLL button to toggle between the min range and the max range. Use the
UP and DOWN buttons to select a numerical value. Once this range is set, you will have to ensure the sink is filled
with water to meet your minimum setting, but not exceed your maximum. Any variation below the minimum or
above the maximum will set the alarm off.
Press ENTER to advance to the next screen.
26.
To calibrate the temperature, place a thermometer in the sink filled with water and compare the temperature on
the thermometer and the display of the dispenser. If they are not equal, use the UP and DOWN buttons to enter
the correct temperature.
Press ENTER to advance to the next screen.
27.
To turn the temperature hold on or off, use the SCROLL button to toggle between on and off. If you have
mandatory temperature requirements, you should leave the temperature hold on as this will prevent dosing if the
temperature is not within range.
If no temperature requirements are mandatory, select off and the temperature control with remain off.
Press ENTER to advance to the next screen.
ENTER DATE RANGE
TO GET REPORTS
FROM 08-01-13
PRESS UP TO START DATA
DOWNLOAD
TO USB
RUNTIME SCREEN
DISPLAY SELECTION:
LAST DOSE VOLUME YES
DOSAGE COUNTDOWN YES
LEVEL A&B YES
PRESS SCROLL TO
ENTER MAIN CODE
0000
PRESS SCROLL TO CHANGE
USER CODE
PRESS SCROLL TO CHANGE
DATE/TIME
TIME 08:52:06 AM
PRESS SCROLL TO
ENTER MAIN CODE
0000