Idex Knight DoseTech DMS, Инструкция по эксплуатации

Страница: 11 / 26

0901048 Rev. C Page 11
Description of Screen Display
1.
Power on the unit.
For about 2 seconds you will see the screen to the right.
If the system is equipped with a USB interface, the current USB version will be displayed.
2.
If the dispenser has been idle for an extended period of time, the default is an image as shown to the right. The
image is specific to Knight’s product logo unless you have uploaded your own graphic. To uploaded your own
graphic, please refer to step 32 in the programming menu.
To exit the idle mode, press the START button.
3.
Next you will see the top screen to the right. You are currently in the dispensing runtime mode. If the TEMP (F) is
flashing, this means that the temperature is out of range. See troubleshooting section for solutions if needed.
Level A is the default selection. To choose between level A or level B, press A or B button.
Press START to begin dispensing for the selected level. The dispenser will begin pumping in either time-based mode
or flow meter based mode the amount programmed in step 19 of the programming procedures.
4.
To change from the dispensing runtime screen to the soak timer runtime screen, press the UP or DOWN button to
toggle between the dispensing runtime screen and the soak timer runtime screen.
To choose between soak time A and soak time B, press A or B button.
Press START to begin the countdown of the selected soak timer. The display will show a countdown from the time
programmed in step 34 of the programming procedures.
USB Version
Firmware Ver IXXX
17:05:56AM 08/15/13
LAST DOSE VOLUME 000
LEVELS A&B 025/050
Operating DoseTech DMS
17:05:56AM 08/15/13
LAST DOSE VOLUME 000
LEVELS A&B 025/050
17:05:56AM 08/15/13
LAST DOSE VOLUME 000
LEVELS A&B 025/050
17:05:56AM 08/15/13
LAST DOSE VOLUME 000
LEVELS A&B 025/050