1 KW2D Series Smart RFID Reader Statuses and Operations
5-8
KW2D Series Smart RFID Reader User’s Manual
●
During lock operation
"lock mode (during lock operation)" is the status when the KW2D Series Smart RFID Reader holds the tag information.
The KW2D Series Smart RFID Reader transitions from "detection mode" to "lock mode" in the following cases.
•
"Enable (Time)" is selected as Lock Mode under the
Tag Read Settings
on the
RFID Reader Settings
tab and
the detection result is normal.
•
"Enable (Holding)" is selected as Lock Mode under the
Tag Read Settings
on the
RFID Reader Settings
tab, the
detection result is normal, and you keep holding up the RFID tag for more than 1.5 seconds after confirming the
detection result.
●
Unlock operation
When the lock is canceled, the KW2D Series Smart RFID Reader sets the tag information to the initial value and
transitions to "operation mode (running)".
The unlocking method varies based on the contents set in Lock Mode under the
Tag Read Settings
on the
RFID
Reader Settings
tab of KW RFID Configurator.
●
Pausing the lock operation
You can pause the timer that counts the lock time to continue the "lock mode (during lock operation)" status. To pause
the timekeeping, manipulate the value of the coil relay. For details, refer to "2.2 Operate the KW2D Smart RFID
Buzzer
LED
Status
None
The LEDs (green) flash. (250 ms interval)
During lock operation
One long beep
The LEDs (green) flash rapidly. (100 ms interval)
At unlock operation
•
When "Enable (Holding)" is set in Lock Mode for the KW2D Smart RFID Reader and you hold an RFID tag on
it, the KW2D Smart RFID Reader will be in "lock mode (during lock operation)". If you hold another RFID tag
on it, and multiple RFID tags are held on it for more than two seconds, the lock operation will be released.
•
The above card type illustration is an example of the LED indicators at the time of detection, and does not
explain or guarantee the detection position of the RFID tag.
Enable (Holding): Detach RFID tag
Enable (Time):
•
Wait for the specified time to elapse
•
Hold up the same RFID tag again
•
Manipulate the value of the coil relay (
When you hold up the RFID tag again to forcibly release the lock operation, hold up the RFID tag at least 2
seconds apart. If the interval is short, releasing the lock operation may fail.
•
The lock time starts counting down when the RFID tag is removed from the KW2D Series Smart RFID Reader
after the it was held up to the RFID reader and locked.
•
When "Disable" is selected in Lock Mode, the KW2D Smart RFID Reader does not shift to "lock mode (during
lock operation)". The mode shifts from "detection mode" to "operation mode (running)".
