IDEAL Vogue Combi c26, Установка и обслуживание

Страница: 27 / 76

27
INsTALLATION
vogue combination boiler -
Installation and Servicing
26 MAINs WIRINg
The Vogue Combi boiler comes pre-fitted with 1.8m of
mains cable. This must be connected to a permanent live
supply and NOT switched by thermostats/programmers.
For installers wishing to change this cable proceed as
follows.
Replacement wiring should comply with the notes in
Frame 28 & 29.
1. Isolate the mains supply to the boiler.
2. Remove the front panel (refer to Frame 9).
3. Swing the control box down into the service position
(refer to Frame 46).
4. Remove the Live, Neutral and Earth wires from the terminal block.
5. Loosen the cable clamp and withdraw the mains cable.
6. Route the replacement cable back through the cable clamp and
grommet and re-tighten to provide cord anchorage.
7. Connect the Live, Neutral and Earth wires to the terminal strip.
When making the mains electrical connections to the boiler it
is important that the wires are prepared in such a way that the
earth conductor is longer than the current carrying conductors,
such that if the cord anchorage should slip, the current carrying
conductors become taut before the earthing
continued . . . .
25 ELECTRICAL CONNECTIONs
Wiring should be 3 core PVC insulated cable, not less than
0.75mm
2 (24 x 0.2mm), and to BS 6500 Table 16. For IE
reference should be made to the current ETCI rules for
electrical installations.
Connection must be made in a way that allows complete
isolation of the electrical supply such as a double pole switch
having a 3mm (1/8”) contact separation in both poles. The
means of isolation must be accessible to the user after
installation.
Warning. This appliance MUST be earthed.
A mains supply of 230Vac ~ 50 Hz is required.
The fuse rating should be 3A. All external controls and wiring
must be suitable for mains voltage.
Wiring external to the boiler MUST be in accordance with the
current I.E.E. (BS.7671) Wiring Regulations and any local
regulations.
4 6
L N E
IN
s
T
ALLA
TION