Ideal-Tridon Strapbinder, Руководство по эксплуатации, частям и безопасности

Страница: 9 / 40

If the red indicator light is "BLINKING", the battery pack cannot accept a charge.
!
Check to make sure the battery pack is inserted to the charger properly.
!
Clean the contacts of the charger or battery pack (e. g. by inserting and removing the
battery several times) or replace the battery pack as required.
When the battery pack is fully charged, unplug the charger (unless you're charging another battery
pack) and install the battery pack back into the tool.
INSTALLING A BATTERY
1. Hold the tool firmly with one hand.
2. Using your other hand, insert the battery into the
tool with a sliding motion.
3. Firmly push the battery until fully seated. When fully
seated the battery locks in place.
4. To remove the battery press the Red release button
on the battery and slide out.
NOTE: Remove the battery from the tool when not in
use for extended periods of time.
REPLACEMENT BATTERIES & CHARGERS
110 VOLT
BATTERY CHARGER
P/N 800293 P/N 800294
220 VOLT
BATTERY CHARGER
P/N 800293 P/N 800543
9