Ideal-Tridon Strapbinder, Руководство по эксплуатации, частям и безопасности

Страница: 13 / 40

OPERATING INSTRUCTIONS, Continued
3. Press button once to activate the tension cycle.
When tension cycle is complete, tool will
automatically reverse slightly and re-engage J-
Clamp.
Note: Press button once during the tension
cycle for tool quick stop
.
4. After cycle completes lift the tool upwards to
nest (lock) the clamp seal with the cutter
portion of the handle.
5. Continue to pull the handle forward to cut the
tail piece off the completed clamp.
Cycle is complete. Remove scrap tail from tool
by depressing handle or pressing the control
button to run the tool until the tail is removed
then press button again to stop tool.
Continue to apply additional clamps as required
for your application needs.
6. Inspect and test the completed hose assembly.
All hose assemblies must be tested to
manufacturers specifications, NAHAD 5.7.1 test
procedures for industrial hose and application
requirements. See NAHAD 5.6.11 for additional
information regarding preform clamps.
Reprinted text from NAHAD 5.6.11 and 5.7.1 can
be found in this manual under Best Practices
for Hose Assembly.
13