Ideal-Tridon Strapbinder, Руководство по эксплуатации, частям и безопасности

Страница: 14 / 40

OPERATING INSTRUCTIONS FOR BENCH MOUNTED (J-Clamp Preforms Only)
Review standard operating instructions before using a bench mounted tool.
1. Insert the tool into Benchmount fixture (Part No. 800506) as shown below.
2. Connect foot pedal plug (Part No. 800489) into the back of the tool.
3. Set desired tension level (review page 9 of this manual).
4. Place clamps on to the hose assembly. Insert clamp tail into front of tool. Press and hold the
foot pedal until cycles completes.
Note: The foot pedal can be released at any time during tensioning to stop the cycle.
5. Once the cycle completes, roll the hose upward to nest (lock) the clamp seal.
6. Pull the handle forward to cut the tail piece off the completed clamp.
7. Press foot pedal and hold until the excess tail is easily and safety removed from the back side
of the tool.
BENCH INSTALLATION
14