Ideal-Tridon Strapbinder, Руководство по эксплуатации, частям и безопасности

Страница: 36 / 40

MAINTENANCE PROCEDURES - FEEDWHEEL CLEARANCE
The feedwheel to roller clearance may require readjustment
if the feedwheel or roller has been replaced. The freewheel
clearance should also be inspected during routine tool
maintenance procedures. Adjust the feedwheel clearance
as follows:
1. Using a 2.5mm hex wrench turn the adjustment screw
which can be accessed through the top of the tool as
shown.
2. Turn the adjustment screw clockwise for greater
clearance and counter-clockwise for less clearance.
Turn the adjustment screw only in 1/8 turn increments.
After each 1/8 turn, test the tool from proper operation.
NOTE: Improper gap clearance may increase chance of
milling of clamp material.
36