Ideal-Tridon Strapbinder, Руководство по эксплуатации, частям и безопасности

Страница: 11 / 40

Wear safety glasses and gloves. Stand to one side of the clamp when tensioning.
Make sure all bystanders are clear before proceeding.
OPERATING INSTRUCTIONS
PLEASE NOTE: Do not operate tool without clamp/banding, as damage to the tool may occur.
SELECTING OPERATING MODE
The tool is easily changed between clamping modes. When in MODE selection the tool will not
operate.
1. Verify a battery is installed properly into tool.
2. Turn Tension Control Knob all the way counter clockwise to
enter
MODE selection.
A. 1 flash on Operation Button: J-Clamp Mode
B. 2 flashes on Operation Button: Band and Buckle Mode
C. 3 flashes on Operation Button: Center Punch Mode
Note: When entered into MODE select the Operation Button
will flash the current MODE.
3. Press the Operation Button to toggle between modes.
4. When correct mode is selected turn Tension Control Knob
clockwise to the appropriate tension level (1 through 5).
Note: When exiting MODE selection the Operation Button
will once again flash the selected mode. When the tension
knob is set between 1-5, the tool is ready to operate.
5. Tool is ready to operate.
Note: When inserting the battery the operation button will
typically flash indicating what mode the tool is in. If the
battery is changed very quickly within seconds the light
may not illuminate.
11