Ideal Heating ECOMOD AHP60 14 kW, Установка и обслуживание

Страница: 43 / 70

01.07.2022 43 / 70
AHP60-14/18 -
Installation, Use and Maintenance
4.2. Switching On
-To switch on the machine, turn the outer handle of the isolator switch to the ON position (shown
by “I”). The display on the machine will only be switched ion if the order of the phases is correct
(to be checked when switched on for the first time). After powering down, wait for at least 1
minute before powering up again.
-Check if the electrical resistors of the compressors are powered correctly.
4.3. Commissioning
-The heat pump must only be commissioned by Ideal Heating commissioning personnel.
-If heating is required before the planned commissioning date, back-up generators may be used:
Ecomod heating system only via the tank back up resistors.
Ecomod hot water system via the gas boiler and the coil tank finisher.
4.4. Adjustment of the heat pump hydraulic flow
The heat pump hydraulic flow balance is under the installator responsibility. Please refer to
the Ecomod Heat Pump Control manual adapted to your application (heating / Hydramax) in
order to know the location of the adjustment devices as well as the target value of flow. Chapter
9.HYDRAULIC DIAGRAMS AND SETTINGS
Always turn off the machine before intervening in the electrical panel.
The forced operation of the pump for the duration of the adjustment, is done in unplugging the
CN10 connector on the main control board.