Modular Power Series
855-340-004_Rev2.0_Instruction Manual
Page
49
of 81
overcurrent level. Set the threshold to 0 amps to disable this alarm. The
default setting is 0 (Disabled).
Battery Low SOC Alarm
SOC Threshold
: Set this to receive an alarm notification when the
battery state of charge falls below the specified level. Set the threshold
to 0 amps to disable this alarm. This setting is only available if the system
is configured for use with a lead-acid type battery. The default setting is
0 (Disabled).
Alarm Reporting
Activate Alarm Form C Contact:
Select the check box to have the rear
panel alarm contacts change state for an alarm condition. The default
setting is Enabled.
Send E-mail:
Select the check box to have an e-mail sent to the e-mail
addresses set up on the communications page for an alarm condition
(see Section 4.7.3). The default setting is Disabled.
Ignore Circuit Breaker 2 Status
: Select the check box to prevent alarm
e-mails being sent when a single battery is connected to a BMMD. This
setting is only available if a BMMD is installed. The default setting is
Disabled.
