Modular Power Series
855-340-004_Rev2.0_Instruction Manual
Page
61
of 81
Download Log (CSV):
Click on the Download Log (CSV) button to store
the CSV format log file on the computer for further analysis.
NOTICE
Updating the firmware will delete the current log file. Download
the log before updating the firmware.
NOTE: Save Settings to enable any changes made.
4.7.2 NETWORK SETUP
Use this tab to configure the unit’s network settings.
NOTICE
Saving any changes to the network settings will cause the ICM to
re-start, causing momentary loss of communications.
Network
MAC Address:
Shows the MAC address assigned to the unit. It is also
shown on the LCD Network Status screen.
Enable DHCP:
Select the check box if the network uses a DHCP server
to automatically assign IP addresses. The default is Enabled.
To manually assign a static IP address to the unit uncheck this box, then
set the following parameters.
IP Address:
Set a unique IP address for the unit.
Subnet Mask:
Set the mask for the subnet the unit is located on.
