Modular Power Series
855-340-004_Rev2.0_Instruction Manual
Page
65
of 81
Trap Community
: Set the community string/password that will be sent
with all SNMPv1 traps. Some trap receivers can filter based on Trap
Community. This field is only used for v1 traps.
Trap User Name:
Set the username for SNMPv3 traps. This field is only
used for v3 traps.
Authentication Protocol:
Set the authentication protocol for SNMPv3
traps (None, MD5, or SHA).
Authentication Password:
If an authentication protocol is selected, set
the authentication password for SNMPv3 traps.
Privacy Protocol:
Set the privacy protocol for SNMPv3 traps (None, or
AES).
Privacy Password:
If a privacy protocol is selected, set the privacy
password for SNMPv3 traps.
Trap IP Addresses:
Set the IP addresses for up to two devices that will
receive SNMP traps from the unit.
NOTE: Save Settings before selecting a different tab.
4.7.3 E-MAIL SETUP
Use this tab to configure all e-mail settings to enable automatic e-mail
notifications directly from the unit. The information required for this is
available from the Network Administrator, or Internet Service Provider (ISP).
