![background image](http://html.mh-extra.com/html/icom/ic-910h/ic-910h_instruction-manual_611497074.webp)
72
11
OPTION INSTALLATIONS
The UT-106 provides AF DSP functions such as noise
reduction and auto notch.
Up to 2 DSP units can be installed for simultaneous
DSP operation for both MAIN and SUB bands.
When only 1 DSP unit is installed, DSP functions can
be operated in either the MAIN or SUB band, whichev-
er is being accessed.
NOTE: The insulating soft case is not used with the
IC-910H.
RECOMMENDATION:
When installing only 1 DSP unit, you can install into
either front or rear panel side. However, installing a
DSP unit into the front panel side may be easier and
also safer.
D
Installing 1st DSP unit (front panel side)
q
Remove the top and bottom covers.
• Remove the UX-910 if you have installed it. (p. 73)
w
Remove the shielding plate.
e
Remove the connection cable from J1751 on the
MAIN unit. Connect the cable into J1 on the UT-
106.
r
Plug the connection cable (P1) from the UT-106 to
J1751 on the MAIN unit.
t
Plug the flat cable into J3 on the UT-106 and to
J1771 on the MAIN unit.
• Take care of the conductor direction.
• Attach the Velcro tape to the UT-106 and PLL unit
shielding plate.
y
Return the shielding plate, top cover and bottom
cover to their original positions.
Take care of the
conductor direction.
J1771
J3
J1
J1751
Shielding plate
UT-106
MAIN unit
P1
PLL unit
D
Installing 2nd DSP unit (rear panel side)
q
Remove the top and bottom covers.
• Remove the UX-910 if you have installed it. (p. 73)
w
Remove the shielding plate.
e
Remove the connection cable from J1761 on the
MAIN unit. Connect the cable into J1 on the UT-
106.
The cable between J1221 on the MAIN and J1
on the DSP unit, must be set in the groove of the
chassis (see diagram below).
Otherwise, the cable may be damaged when re-
turning the shield plate to its original position.
r
Plug the connection cable (P1) from the UT-106 to
J1761 on the MAIN unit.
t
Plug the flat cable into J3 on the UT-106 and to
J1781 on the MAIN unit.
• Take care of the conductor direction.
• Attach the Velcro tape to the UT-106 and PLL unit
shielding plate.
y
Return the shielding plate, top cover and bottom
cover to their original positions.
J1781
J1761
J3
J1
Shielding plate
UT-106
MAIN unit
PLL unit
Take care of the
conductor direction.
P1
J1
Set cable into the groove.
n
UT-106
DSP UNIT
Содержание IC-910H
Страница 1: ...INSTRUCTION MANUAL VHF UHF ALL MODE TRANSCEIVER i910H ...
Страница 86: ...84 MEMO ...
Страница 87: ...85 MEMO ...