21
PREP
ARING THE
APPLIANCE
14.
Turn off the appliance, turning the main machine switch (1) to "0",
and turn the key (2) a quarter turn to the left (
Fig.1
). Remove the
key from the instrument panel.
15. Grip the handle (3) on the left side of the recovery tank (
Fig.2
) and
turn the tank as far as it will go, until it reaches the maintenance
position (
Fig.3
).
16. Disconnect the battery hopper connector (4) from the connector
of the general system (5)
Fig.13
).
ATTENTION:
This process must be carried out by qualified
personnel.
17. Grip the handle (3) on the left side of the recovery tank and turn
the tank until it reaches the work position (
Fig.5
).
HOW TO TRANSPORT THE APPLIANCE
To transport the machine, proceed as follows:
1.
Check that the solution tank and recovery tank are empty. If
they are not, empty them (read the paragraph “
AND CLEANING THE RECOVERY TANK
” or read the
CHECKING AND CLEANING THE SOLUTION
”).
2. For Scrub 50D versions, make sure the device is switched off. If it
isn't, press the main switch (1) on the back of the device (
Fig.1
).
ATTENTION:
in Scrub 50D versions, the main switch (1) is in
the idle position when the LED inside it is OFF and the
activation symbol is not visible.
3. For traction versions, make sure the device is switched off. If it
isn't, bring the main switch (2) to the “0” position by making a
quarter turn to the left with the key (3) (
Fig.2
). Remove the key
from the instrument panel.
4. Grip the handle (4) on the left side of the recovery tank (
Fig.3
) and
turn the tank as far as it will go, until it reaches the maintenance
position (
Fig.4
).
5. Disconnect the connector of the general system (5) from the
connector of the batteries (6)
Fig.5
).
ATTENTION:
This process must be carried out by qualified
personnel.
6. Grip the handle on the left side of the recovery tank and turn the
tank until it reaches the work position (
Fig.6
).
7. For traction versions, release the electronic brake and turn the
lever (7) in the direction of the arrow. The traction gearmotor is
located on the left side of the device (
Fig.7
).
8. Using a chute, slide the machine onto the pallet.
9. For traction versions, engage the electronic brake and turn the
lever (7) in the direction of the arrow. The traction gearmotor is
located on the left side of the device (
Fig.8
).
10. Secure the device to the pallet using the wedges.
ATTENTION:
for transportation without a pallet, secure the
device according to the directives in force in the country of use
so that it does not slide or tip over.
5
4
13
3
3
7
1
3
2
6
5
4
4
1
2
5
OFF
4
8
7
7
