40
WORK
REVERSE MOVEMENT (traction version)
This machine is equipped with electronically controlled traction. To
reverse, proceed as follows:
1. Check that the knob (1) is set to minimum, if not, turn it counter-
clockwise(
Fig.1
).
2. C
heck that the brush head unit is raised off the floor, pressing the
pedal (2) on the back of the device if necessary (
Fig.2
).
3.
Check that the squeegee unit is raised off the floor, adjusting the
lever (3) on the back of the device if necessary (
Fig.3
).
4.
Turn the main machine switch to "I", making a quarter turn to the
right with the key (4) (
Fig.4
).
5. Press the “REVERSE MOVEMENT ACTIVATION -
DEACTIVATION” button (5) on the control panel (
Fig.5
).
6. Engage the dead man's levers (6) on the handlebars (
Fig.6
) to
start moving the appliance in reverse mode.
ATTENTION:
as soon as you press the button (5) on the
control panel (
Fig.5
), the control display will show the
“REVERSE” screen (
Fig.7
).
ATTENTION:
the reverse speed is lower than the forward
speed to comply with current health and safety standards. If
the potentiometer is adjusted while reversing, the adjustment
of the forward speed will be automatically changed.
ATTENTION:
it is impossible to reverse if the squeegee unit
touches the floor. In order to reverse, lift the squeegee unit
from the floor using the relevant lever on the back of the
appliance.
ATTENTION:
to disable reverse movement, press the button
(5) on the control panel again (
Fig.5
).
ATTENTION:
as soon as the button (5) is pressed, the
acoustic signal advising that reverse function has been
activated will sound.
EMERGENCY SWITCH (traction version)
This device has an emergency switch, to activate it just press the
button (1) on the rear of the device.
ATTENTION:
This command interrupts the electrical circuit
between the batteries and the machine system.
ATTENTION:
After stopping and resolving the problem, turn
the key to “0”, set the button (1) to the standard position and
turn the key to “I” to resume the work.
ATTENTION:
As soon as the emergency button is pressed,
the control display show the symbol (2) (
Fig.2
) it will continue
flashing until the switch is brought back to its standard
position.
1
2
4
3
2
4
1
3
6
5
6
5
7
1
1
2
2
