iCanTek iCanView 230, Руководство пользователя

Страница: 13 / 54

iCanView230/230W User’s Guide
2. Apply power to iCanView230/230W
3.
Install “IP installer” and “i-NVR” on your PC.
Detailed information for installing these programs can be found in
[IP-Installer User’s
Guide] and [i-NVR User’s Guide] , respectively.
4.
Assign IP address to iCanView230/230W using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
[IP-Installer User’s Guide] . If network type is
xDSL or Cable modem you need supplementary information provided by your ISP.
5. Connect to iCanView230/230W in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when iCanView230/230W is delivered. You
are asked to configure the system for your environment in administration mode. Detailed
information of using administration mode can be found in
[5. Configuring
iCanView230/230W in Administrative Mode] . Among the parameters, the parameters
in the following table should be set-up with proper values. Detailed information for the
parameters in Administrator Mode is found in
[5. Configuring iCanView230/230W in
Administrative Mode]
[Note]: Set-up values are preserved even the power is turned off.
Page Parameter Setup value Factory default value
Video Size
Set the resolution of the video
transmitted from iCanView230/230W.
Max Upload Rate
Set this value smaller than the upload
speed of your network.
Frame Rate
The number of frames to be
transmitted per second.
Basic Setup
Video Rate
Bandwidth assigned for video
transmitted from iCanView230/230W.
Make sure that you press Check
button to find out the number of
maximum possible simultaneous
users then set the number of
users smaller than or equal to the
number.
User Admin
& Time
Setup
Administrator
name &
password
For safety, you are recommended to
change these values from factory
default. For new connection, you need
to input changed values for
corresponding fields. Do not disclose
Default value
Username : root
Password : dw2001
Rev.1.0 (Aug. 2006)
13 of 54