IBM xSeries 260, Руководство пользователя

Страница: 55 / 312

Changing the Display Language
The text on the 8mm Tape Drive LCD is available in several languages. To change
the language:
1. Press and hold the unload button after you turn the power on to the 8mm Tape
Drive or, if your system unit is already running, press and hold the unload button
for approximately 15 seconds until the LCD displays
RESET
. Release the unload
button for approximately one second, then press and hold the unload button
again.
2. After the LCD cycles through all the reset messages , it cycles through the
available languages. When the desired language displays, release the unload
button.
Loading the 8mm Tape Cartridge
Before loading the tape cartridge, make sure the system unit power is on and that
the write-protect tab on the tape cartridge is properly set. Refer to “Setting the
Write-Protect Tab on 8mm Tape Cartridges” on page 2-19. The tape drive loads the
tape from the cartridge and prepares it for reading and writing.
1 Window side of tape cartridge
2 8mm tape cartridge
3 Write-protect tab
To load the 8mm tape cartridge:
1. Grasp the edges of the 8mm tape cartridge with the write-protect tab toward you
and the window side of the cartridge facing up.
2. Slide the tape cartridge into the opening on the front of the 8mm tape drive until
the loading mechanism pulls the cartridge into the drive and the drive door
closes. The ready status light (green) comes on if the load operation was
successful.
Chapter 2. Using the System Unit
2-23