IBM xSeries 260, Руководство пользователя

Страница: 144 / 312

Installing a CD-ROM Drive, Tape Drive, Diskette Drive
CAUTION:
Do not open the drive; no user adjustments or serviceable parts are inside.
1. If you have not already done so, shutdown the system as described in “Stopping
the System Unit” on page 4-3.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
3. If you have not already done so, remove the left side, right side, and front covers
as described in “Removal of Covers” on page 4-4.
4. If your are installing a 6156 8MM tape drive, in your system unit remove the top
cover, “Removal of Covers” on page 4-4. if not go to step 5
a. When installing the 6156 8MM tape drive, move the EMC clip from the front
(1) to the back (2). Make sure the rounded part of the EMC clip is facing
down. (If there are two EMC clips remove the front clip and leave the one in
the back).
b. Pull the tab that is located on the left side out a little way to remove and or
move the EMC clip.
1
2
5. Connect the cables from the front of the system.
a. Locate the appropriate data cable for the drive. Connect the cable to the
connector at the rear of the drive.
b. If you are installing a CD-ROM drive, connect the audio cable from the I/O
board to the audio connector at the rear of the drive.
c. If you are installing a SCSI drive, set the SCSI address jumpers at the rear
of the drive to the correct address. Refer to the documentation that came
with your drive for details on setting the SCSI address.
d. The two media bays share a common power cable. Connect an available
connector on the power cable to the 4-pin connector at the rear of the drive.
4-32
User's Guide