IBM xSeries 206m, Руководство по диагностике и обслуживанию

Страница: 51 / 144

6. Touch the static-protective package that contains the adapter to any unpainted
metal surface on the server. Then, remove the adapter from the
static-protective package. Avoid touching the components and gold-edge
connectors on the adapter.
7. If the adapter is a ServeRAID 8i controller, complete the following steps to
install the low-profile expansion-slot bracket on the adapter:
a. Unscrew the two screws that hold the large expansion-slot bracket on the
adapter.
b. Remove the large bracket.
c. Install the low-profile (small) expansion-slot bracket in the same position on
the adapter.
d. Reinstall the two screws that you removed in step 7a.
Attention: When you install an adapter, make sure that it is completely and
correctly seated in the expansion slot in the riser card. Incomplete insertion
might cause damage to the riser card, system board, or the adapter when you
turn on the server.
8. To install the adapter in the riser-card assembly, carefully grasp the adapter by
its top edge or upper corners, and align it with the expansion slot; then, press
the adapter firmly into the expansion slot.
9. Follow the cabling instructions, if any, that come with the adapter. Route the
adapter cables before you reinstall the riser-card assembly.
10. Carefully align the riser-card assembly with the guides on the rear of the
server and with the riser-card connectors on the system board; then, press
down on the assembly. Make sure that the riser-card assembly is fully seated
in the riser-card connectors on the system board.
11. Install the cover (see “Installing the cover” on page 31).
12. Slide the server into the rack.
13. Connect the cables and power cords (see “Completing the installation” in the
Installation Guide or User’s Guide for cabling instructions).
14. Turn on all attached devices and the server.
Hard disk drive
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this chapter.
Attention: To avoid damage to the hard disk drive connectors, make sure that the
server cover is in place and fully closed whenever you install or remove a hard disk
drive.
Removing a simple-swap Serial ATA hard disk drive
To remove a simple-swap SATA drive from the bay, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 27.
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and
all external cables.
4. Remove the filler panel from the bay.
5. Pull the loops of the drive tray toward each other and pull the tray out of the
bay.
Chapter 4. Removing and replacing server components
35