IBM xSeries 206m, Руководство по диагностике и обслуживанию

Страница: 31 / 144

Note: To add RAID functionality to a hot-swap SATA model, see “Using the
SAS/SATA Configuration Utility program (for SAS/SATA HostRAID)” on page 16.
For additional information about using the Adaptec RAID Configuration Utility
programs, see the documentation on the IBM ServeRAID-8e (Adaptec HostRAID)
Support CD. If this CD did not come with the server, you can download it from
http://www.ibm.com/support/.
The integrated SATA RAID feature (SATA HostRAID) comes disabled by default.
You must enable it and install the device drivers before you can use it. The SATA
RAID feature configuration utilities, device drivers, and information are available on
the ServeRAID-8e (Adaptec HostRAID) Support CD.
Enabling the Serial ATA HostRAID feature: Important: A configuration conflict
(error 1801) might occur if SATA RAID and SAS/SATA RAID are both enabled. If
you are enabling the Serial ATA HostRAID feature, make sure the RAID Support
option in the SAS/SATA Configuration Utility program is disabled (for more
information, see “Enabling the SAS HostRAID feature” on page 16).
To enable the SATA RAID feature, complete the following steps:
1. Turn on the server.
2. When the prompt Press F1 for Configuration/Setup appears, press F1. If you
have set an administrator password, you are prompted to type the password.
3. Select Devices and I/O Ports --> Advanced Chipset Control --> Serial ATA .
4. Select SATA Controller Mode Option . Change the value to Enhanced .
5. Scroll down and select SATA RAID Enable .
6. Select Enabled .
7. Press Esc; then, select Yes to save your changes.
Using the Serial ATA HostRAID feature: The instructions in this section are for
using the Array Configuration Utility program to access and perform an initial RAID
level-1 configuration. If you install a RAID adapter, use the method described in the
instructions that come with the adapter to view or change settings for the attached
devices.
For additional information about using the Array Configuration Utility program to
create, configure, and manage arrays, see the documentation on the ServeRAID-8e
(Adaptec HostRAID) Support CD.
Configuring the controller: To use the Array Configuration Utility program to
configure a level-1 RAID for the server, complete the following steps.
1. Turn on the server.
2. When the prompt
Press <CTRL><A> for Adaptec RAID Configuration Utility
appears, press Ctrl+A.
Note: If the prompt
Press <CTRL><A> for Adaptec RAID Configuration
Utility
does not appear, start the Configuration/Setup Utility (see “Starting the
Configuration/Setup Utility program” on page 12), select Devices and I/O
Ports --> Advanced Chipset Control --> Serial ATA and make sure the
Serial ATA options are set to the following values:
Native Mode Operation: Auto
SATA RAID Mode Option: Enhanced
SATA RAID Enabled
Chapter 2. Configuration information and instructions
15