IBM Universal Tape Library, Руководство пользователя, Страница: 17 / 96

Chapter 2. Installing and configuring the library
This chapter provides instructions for installing the Universal Tape Library.
Installation guidelines
Before you remove or replace a device, read the following information:
v
Read the safety information that begins on page v and “Handling static-sensitive
devices.” This information will help you work safely.
v Observe good housekeeping in the area where you are working. Place removed
covers and other parts in a safe place.
v
Do not attempt to lift an object that you think is too heavy for you. If you have to
lift a heavy object, observe the following precautions:
– Make sure that you can stand safely without slipping.
– Distribute the weight of the object equally between your feet.
– Use a slow lifting force. Never move suddenly or twist when you lift a heavy
object.
– To avoid straining the muscles in your back, lift by standing or by pushing up
with your leg muscles.
v
Make sure that you have an adequate number of properly grounded electrical
outlets for the server and all attached devices.
v Back up all important data before you make changes to disk drives.
Review the documentation that comes with your rack cabinet for safety and cabling
information. Before you install the library in a rack cabinet, consider the following
guidelines:
v Two or more people are required to install the device in a rack cabinet.
v
Make sure that the room air temperature is below 35°C (95°F).
v Do not block any air vents; usually 15 cm (6 in.) of space provides proper airflow.
v
Do not leave open spaces above or below an installed device in your rack
cabinet. To help prevent damage to the device and ensure proper air circulation,
always install a blank filler panel to cover the open space and to help ensure
proper air circulation.
v Plan the device installation starting from the bottom of the rack cabinet.
v
Install the heaviest device in the bottom of the rack cabinet.
v
Do not extend more than one device out of the rack cabinet at the same time.
v Do not overload the power outlet when you install multiple devices in the rack
cabinet.
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices. To avoid damage,
keep static-sensitive devices in their static-protective packages until you are ready
to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
© Copyright IBM Corp. 2007
7