IBM TotalStorage Ultrium 3580 H23, Руководство по настройке и эксплуатации

Страница: 88 / 149

Function Code 7: Run RS-422 Wrap Test
This test is not available and cannot be performed.
Function Code 8: Unmake FMR Tape
Function Code 8 erases the field microcode replacement (FMR) data and rewrites
the cartridge memory on the tape. This converts the cartridge into a valid scratch
(blank) data cartridge.
1. Make sure that no cartridge is in the drive.
2. Make sure that the following message appears on the message display (you
may need to turn the power off, then on again for the message to appear):
Ultrium Tape Drive
Drive Empty
3. Within two seconds, press the unload button 3 times. The status light becomes
solid amber and the following message displays (indicating that the tape drive
is in maintenance mode):
Maint Mode: Select
Exit Maint Mode
Note: If a cartridge is in the tape drive, it will eject the first time that you press
the unload button and the drive will not be placed in maintenance
mode. To continue placing the drive in maintenance mode, perform the
preceding step.
4. Press the unload button once per second until
8
appears in the single-character
display and the following message displays. (If you cycle past the desired code,
press the unload button once per second until the code redisplays.)
Maint Mode: Select
Unmake FMR Tape
5. Press and hold the unload button for 3 or more seconds, then release it to select
the function. Immediately after the following message displays, insert the FMR
data cartridge (or the tape drive exits maintenance mode).
Unmake FMR Tape
Load Drv FMR Tape
After you insert the FMR cartridge, the flashing
C
in the single-character
display changes to
8
and the following message displays:
Unmake FMR Tape
Tape Loading = = = >
followed by:
Unmake FMR Tape
Writing = = = >
72
IBM 3580 Ultrium Tape Drive Setup and Operator Guide