IBM ThinkPad R30, Руководство оператора

Страница: 207 / 276

Hardware Problem Determination
11-13
7. Starting at the top of the following table, find your symptom; then perform the specific
action.
Symptom Action
The system stops with a blank operator panel
display, and the words
DIAGNOSTIC OPERATING
INSTRUCTIONS
are displayed with no obvious
problem on the console display (for example, it is
not distorted or blurred).
Go to Step 10.
The system stops with a blank operator display and
the MAINTENANCE MENU is displayed. Select System boot, then Boot
From List, and continue with this
step.
The system stops with a blank operator panel
display, and the words
DIAGNOSTIC OPERATING
INSTRUCTIONS
are not displayed correctly.
Go to Step 9.
The system stops with
260
,
261
, or
262
displayed
in the operator panel display.
Record and report SRN
111
–
101
.
STOP. You have completed
these procedures.
The system stops with a steady (not flashing)
number displayed in the operator panel display, and
the power-on light is on. The number must be other than
c07
or
c31
. See previous
substep 4 for these numbers.
Go to Step 7.
The system stops with
888
flashing in the operator
panel display.
Go to Step 8.
The system stops with two or more numbers
between
221
and
296
alternating in the operator
panel display.
Record and report SRN
111–101
.
STOP. You have completed
these procedures.
Step 19
(From Steps 12, 13)
The diagnostics did not find a hardware problem. If you still have a problem, contact your
software support center. If you are attached to another system, refer to General Information
About Multiple Systems on page 2-1 and check your configuration before calling the
software support center.
Step 20
(From Steps 6, 18)
When the
c31
halt was present, were the instructions to select a console display
readable with no obvious problems with the display?
NO Go to Step 9.
YES Go to Step 11.