IBM System Storage TS2240, Руководство по установке, эксплуатации и обслуживанию

Страница: 59 / 141

Attention: Even though no data is written during this test, it is recommended that
you use a blank (scratch) cartridge for this test.
1. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page 3-9.
2. Press the Unload Button once per second until
L
appears in the SCD. (If you
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press and hold the Unload Button for three or more seconds, then release it to
select the function. The SCD changes to a flashing
C
.
4. Insert a scratch (blank) data cartridge. The SCD changes to a flashing
L
and
the tape drive runs the tests.
v If no error is detected, the diagnostic will loop and begin again. To stop the
loop, press the Unload Button for one second and release. When the loop
ends,
0
temporarily appears in the SCD.
v
If an error is detected, the Status Light flashes amber and the drive posts an
error code to the SCD. To determine the error, locate the code in Appendix A,
“Error Codes and Messages,” on page A-1. To clear the error either turn the
power off and then on again, or reboot the drive by pressing and holding the
Unload Button for 10 seconds.
Function Code P: Post Error Reporting Enabled
When Post Error Reporting is enabled, deferred-check conditions are reported to
the host and temporary errors are reported in the sense data. Function Code
P
will be displayed in Maintenance Mode when the drive has Post Error Reporting
enabled.
This selection is normally used as a request from support personnel.
1. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page 3-9.
2. Press the Unload Button once per second until either
P
or
U
appears in the
SCD.
P
or
U
will appear in the SCD to indicate the current setting for Post
Error Reporting. If you cycle past the desired code, press the Unload Button
once per second until the code reappears.
3. Exit Maintenance Mode if you do not want to change the current setting for Post
Error Reporting. For instructions, see “Exiting Maintenance Mode” on page 3-9.
4. To disable Post Error Reporting, Press and hold the Unload Button for three
seconds while
P
appears in the SCD. The SCD changes to
U
after you
release the Unload Button.
5. Press the Unload Button once per second to select another Maintenance Mode
Function. To exit Maintenance Mode, refer to “Exiting Maintenance Mode” on
page 3-9.
Chapter 3. Operating
3-21