IBM System Storage TS2240, Руководство по установке, эксплуатации и обслуживанию

Страница: 49 / 141

“Error Codes and Messages,” on page A-1. To clear the error either turn the
power off and then on again, or reboot the drive by pressing and holding the
Unload Button for 10 seconds.
Function Code 2: Update Drive Firmware from FMR Tape
Attention: When updating drive firmware, do not power-off the drive until the
update is complete or the firmware may be lost.
Function Code
8
loads drive firmware from a field microcode replacement (FMR)
tape. The FMR tape must have been created from a LTO 4 tape drive with the
same host interface (e.g. SCSI, SAS, Fibre Channel).
1. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page 3-9.
2. Press the Unload Button once per second until
8
appears in the SCD. (If you
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press and hold the Unload Button for three or more seconds, then release it to
select the function. The SCD changes to a flashing
C
.
4. Insert the FMR tape cartridge. The SCD changes to a flashing
8
. The Amber
Fault Light will be ON solid during tape movement and flashing while code is
being loaded. The Green Ready Light will be OFF. The tape drive loads the
updated firmware from the FMR tape into its erasable programmable read-only
memory (EPROM) area.
v
If the update completes successfully, the tape drive rewinds and unloads the
FMR tape, resets itself, and is ready to use the new firmware. The drive
automatically reboots.
v If the update fails, the tape drive posts an error code to the SCD. To
determine the error, locate the code in Appendix A, “Error Codes and
Messages,” on page A-1. Push the Unload Button to eject the cartridge. The
drive exits Maintenance Mode after the cartridge is removed. Contact IBM
Technical Support for problem determination or machine replacement.
Function Code 3: Create FMR Tape
Function Code
3
copies the drive’s field microcode replacement (FMR) data to a
scratch data cartridge. The resulting FMR tape can only be used to update the
firmware on other LTO Gen4 tape drives with the same host interface (SCSI, SAS,
or Fibre Channel).
Attention: For this function, insert only a scratch (blank) data cartridge or a
cartridge that may be overwritten. During the test, the drive overwrites the data on
the cartridge.
Note: If you inserted an invalid tape cartridge (e.g. Gen1 or WORM media), error
code
7
appears in the SCD. If you inserted a write-protected cartridge, or
the media has read-only compatibility (e.g., Gen2 media), error code
P
Chapter 3. Operating
3-11