IBM SelectaDock II, Руководство пользователя

Страница: 122 / 168

Drive Letters
When you use the computer with the SelectaDock system, the drive
letters assigned to the drives in the computer and in the docking
system can change when docked and undocked. If the drive letter
changes, the program running normally in the undocked state may not
work when docked.
To avoid problems caused by change of the drive letter:
Check the new drive letters after docking.
Do not make a primary partition on the hard disk drive in the
SelectaDock system.
Check the source drive and the target drive when you make a file
copy or file move operation.
Check the drive of the file to be erased.
Check the drive you will format.
Do not register programs on the desktop of your operating system
when the drive letter of the program changes from the docked to
the undocked state.
Selecting Startup Drives
Usually, the same startup drive is used to boot an operating system
for both the stand-alone and the docked environment. However, if you
need to boot from a drive in the SelectaDock system, you must
change the startup sequence accordingly.
To set up the startup sequence, do the following:
1
Install the additional hard disk in the docking station, if not yet
installed.
2
Start Easy-Setup by pressing and holding the F1 key while
turning on the computer.
110
IBM ThinkPad SelectaDock II User's Guide