IBM PC 300GL Types 6275, Руководство по установке

Страница: 61 / 94

Installing a 5.25-Inch Drive in the 3-Bay Design
Notes:
1. The following instructions are for installing a drive. If you want to replace a
drive, first go to “Removing a 5.25-Inch Drive from the 3-Bay Design” on
page 49.
2. To install a 3.5-inch drive into drive bay 1, you must install a conversion kit.
For information on purchasing a 3.5-inch conversion kit for a 5.25-inch bay, see
your place of purchase or an IBM reseller.
Before you begin
Ÿ
Read “Electrical Safety” on page 3 and “Handling Static-Sensitive Devices”
on page 4.
Ÿ
Read the instructions that come with the drive you want to install or replace.
Ÿ
Turn off the computer and all other connected devices.
Ÿ
Disconnect all cables attached to the computer and remove the computer
cover (see “Disconnecting Cables and Removing the Cover” on page 5).
1
If a drive is installed in bay 2, disconnect any cables that are attached.
2
Remove the bracket that houses bays 1 and 2 by removing the screws at the
front and sliding the bracket backwards to clear the alignment slots. Lift the
bracket from the computer.
Alignment
Slots
Screws
Removable
Drive Bracket
Alignment Slots
Chapter 5. Working with Internal Drives
47