IBM PC 300GL Types 6275, Руководство по установке

Страница: 34 / 94

To replace the microprocessor:
1
If you have the 3-bay design, remove the 3.5-inch drive bracket. For more
information, see steps 1 and 2 on page 45.
2
If an adapter impedes your access to the microprocessor, remove it. For more
information, see “Removing an Adapter” on page 32.
CAUTION:
When removing the microprocessor, be careful not to scrape any system
board component. Also, the retaining clamp is under tension and may
disengage suddenly if it is not held while it is being removed.
3
The slots on the ends of the clamp hook over the tabs found on the
microprocessor connector. Remove the clamp by pressing down on it and
releasing the tabs on each end of the clamp.
Socket 5
Socket 8
Socket 8
Socket 8
Heat Sink
Clamp
Note: A thermal grease is used to seal the heat sink to the microprocessor
and to maintain safe operating temperatures. If the heat sink is
permanently cemented to the microprocessor, you can remove both the
heat sink and the microprocessor after you lift the lever in step 5.
Also, be careful not to get the grease on your skin. If the grease
touches your skin, wash the area with soap and water.
20
Installing Options in Your Personal Computer