IBM Nways 2216, Руководство по установке и первоначальной настройке

Страница: 46 / 66

Remote File Download
Question How do I download a configuration file to the 2216 using the Firmware
Menu System?
Answer Use the Systems Management Services.
1
Using a local console, select 4. Disable Unattended Mode from
the Systems Management Utilities menu in the firmware to put the
2216 in ATTENDED mode. (Be sure to remember the password)
2
To put the 2216 into the correct monitor mode for the remote
console that is going to be used, reboot the 2216 and press Y at
the
DO YOU WANT TO CHANGE THE MONITOR TYPE? prompt. Select
the number next to the option for the Monitor type.
3
Remove the local console connection and reboot the 2216 again.
Do a hardware reset to put the 2216 in ATTENDED mode. (Do
not use the reload command.)
4
Wait at least 90 seconds for the 2216 to reach the POWER-ON
PASSWORD after rebooting before attempting to remotely connect
to the 2216.
5
Dial in to the 2216’s PCMCIA modem with a TTY console. The
console settings must be:
Speed = 19200 bps
Data bits = 8
Parity = No
Stop bits = 1
6
Once the connection is established, type in the password and
press Enter. The password will not be displayed, but you should
get an * on your screen for every character that you enter.
7
Press F1 to terminate the boot sequence and enter the firmware
Systems Management Services menu.
8
Select 4. Utilities from the Systems Management Services menu.
9
Select 12. Change Management from the Systems Management
Utilities menu.
10
For MODEM: Configuration file must be on remote console, but no
IP addresses are needed.
a. Select 12. Xmodem software from the Change Management
Software Control menu.
b. Select 1. Config from the Select Type dialog box.
c. Select the Bank to send the configuration file to from the
Select Bank dialog box.
d. Select the config # to send the configuration file to from the
Select Config dialog box.
B-10
2216 Installation and Initial Configuration Guide