IBM Nways 2216, Руководство по установке и первоначальной настройке

Страница: 40 / 66

Viewing Vital Hardware Data
Question How do I view vital hardware data?
Answer
1
Access the firmware main menu: During boot-up, press F1 at the
Prematurely terminate boot sequence prompt.
2
Select 4. Utilities.
3
Select 9. View or Set Vital Product Data.
4
Select Hardware Vital Product Data. The vital hardware data is
displayed.
5
Return to the firmware main menu.
6
Press F9 to load the operating software.
Adding an Adapter at Initial Configuration
Question How do I add an adapter to the software configuration when the IBM
2216 is being initially configured?
Answer First, perform installation of the 2216 and install any additional adapters
into the 2216. (The section entitled “2216 FRU Exchange” in the
IBM
2216 Service and Maintenance Manual describes the removal and
replacement procedure.
¹
When the 2216 is initially installed, it does not have any software
configuration.
¹
The operating system will put you at the Config only> prompt.
1
Enter add device type of device.
Note: The steps only create the interface. You still have to use
the net command to configure characteristics unique to that
interface (for example, T/R, Ethernet, PPP, FR, SDLC, X.25). You
also need to use the protocol command to configure protocols on
the interface.
For example, add device token
or, add device ? to see a list of device choices
2
Enter the device slot number (1–8).
3
If you are adding an interface on a single-port adapter, go to step
4 on page B-5. Otherwise, continue with this step.
Enter the port number (0–7, depending on the type of adapter).
The range of port numbers supported depends on the multi-port
adapter type:
¹
For the Token-Ring (FC 2280) and Ethernet (FC 2281)
adapters, port numbers 1 and 2 are supported.
¹
For the 8-port EIA-232E/V.24 (FC 2282) and 8-port X.21
adapters, port numbers 0–7 are supported.
B-4
2216 Installation and Initial Configuration Guide