IBM Nways 2216, Руководство по установке и первоначальной настройке

Страница: 7 / 66

About This Guide
This guide explains how to set up the IBM 2216, perform initial configuration, and
correct some problems that might occur during installation.
Who Should Use This Guide
This guide is intended to be used by the person responsible for installing the 2216.
This person should be familiar with installation and cabling charts.
About the Software
IBM 2216 Nways Multiprotocol Access Services (licensed program number
5765-C90) is the software that supports the IBM 2216. This software has these
components:
¹
The base code, which is installed at the factory on the 2216, consists of:
– The code that provides the routing, bridging, data link switching, and SNMP
agent functions for the device.
– The router user interface, which allows you to configure, monitor, and use
the IBM 2216 Nways Multiprotocol Access Services base code that is
installed on the device. The router user interface is accessed locally
through an ASCII terminal or emulator attached to the service port, or
remotely through a Telnet session or modem-attached device.
¹
The Configuration Program for IBM 2216 Nways Multiprotocol Access Services
(
Configuration Program), a graphical user interface that allows you to configure
the device from a stand-alone workstation. The configuration program includes
error checking and online help information.
The configuration program is not preloaded at the factory; it is shipped
separately from the device as part of the software order. (See the
Configuration Program User Guide, GC30-3830, for the server address and
directories to FTP a copy of the configuration program).
How to Proceed
Note: If you are upgrading from Version 1 Release 1 of the Multiprotocol Access
Services (the operating system software) to Version 2 Release 1 (or higher), see
the upgrading/migrating information in the
Service and Maintenance Manual.
Installation and Initial Configuration
1
Install the IBM 2216 using the Installation and Initial
Configuration Guide provided with the product. (Alternatively,
installation by IBM service personnel is available. Contact
your IBM representative for additional information.)
2
Connect a terminal to the serial port or PCMCIA modem to
enable you to do the initial configuration steps. (See “Access
Methods” on page 3-1.)

Copyright IBM Corp. 1997
v