IBM Netfinity 6000R, Руководство пользователя

Страница: 92 / 218

78
IBM® Netfinity® 6000R User’s Reference
Working with adapters
The following illustration shows the location of the Active™ PCI adapter expansion
slots on the system board.
Notes:
1. The illustrations in this document might differ slightly from your hardware.
2. Active PCI slots are also called hot-plug PCI slots.
PCI bus configuration
• Hot-plug, 32-bit PCI slot 1 (on PCI bus A, 33 MHz)
• Hot-plug, 64-bit PCI slots 2 through 4 (on PCI bus B, 66 MHz)
• Hot-plug, 64-bit PCI slots 5 through 6 (on PCI bus C, 33 MHz)
• Power-on lights for Active PCI slots
• Internal Attention lights for Active PCI slots
• External Attention lights for Active PCI slots
This section gives the procedure for installing a hot-plug PCI adapter. If your
operating system supports hot-plug PCI adapters, you can replace a failing hot-plug
PCI adapter with a new adapter of the same type without turning off power to the
server. If your operating system and adapter also support the hot-add feature, you
can install a new adapter without turning off the power to the server.
Before you begin:
• Review the information in “Before you begin” on page 71 and “Working inside
the server with the power on” on page 71.
• Read the documentation that comes with your adapter for any special
requirements or restrictions.
• Read the documentation that comes with your operating system.
PCI slot 1
32-bit
33 MHz (J50)
PCI slot 2
64-bit
66 MHz (J51)
PCI slot 3
64-bit
66 MHz (J52)
PCI slot 4
64-bit
66 MHz (J53)
PCI slot 5
64-bit
33 MHz (J54)
PCI slot 6
64-bit
33 MHz (J55)
PCI hot-plug
switch card
(J1)
PCI slot
attention lights
PCI slot
power-on light