IBM INTELLISTATION E PRO 6204, Руководство пользователя

Страница: 84 / 162

68
IBM® IntelliStation® E Pro: User’s Guide
To install a drive in bay 5, 6, or 7, do the following:
1. Read the information in “Preinstallation steps” on page 66.
2. Turn off the computer and all attached devices. Disconnect all external cables
and power cords; then remove the cover. See “Removing the side cover” on page
58 for details.
3. Remove the support bracket.
4. If your computer has hard disk drives preinstalled in the drive cage, disconnect
the power and signal cables from the rear of the drives.
5. Grasp the drive cage and rotate the cage out (middle view) of the computer until it
locks into place with the drive-cage retention tab. The open ends of the drive
slots and installed drives will face you.
Note: Ensure that the drive cage locks into place over the drive-cage retention
tab by pressing the drive cage all the way up.
6. Attach the guide rails to the side of the drive using the screws provided. If you
obtained your optional drive from IBM, the guide rails are blue plastic.
7. Slide the drive into the drive cage until the plastic tabs on the drive guide rails lock
into place in the drive cage. Clear any cables that might impede the replacement
of the drive cage.
8. Lift the drive cage up, and press in on the drive-cage release tab; then rotate the
cage back into the computer (right view).
9. Connect the power and signal cables to the rear of each drive.
Note: Route the signal cable so that it does not block the air flow to the rear of
the drives or over the microprocessor.
10. If you have other options to install or remove, do so now.
11. Replace the support bracket.
12. Replace the side cover. See “Replacing the cover” on page 73 for details.
13. Reconnect the external cables and power cords; then turn on the attached
devices and the computer.