IBM INTELLISTATION E PRO 6204, Руководство пользователя

Страница: 115 / 162

Chapter 6. Solving problems
99
Novell NetWare or IntraNetWare computer ODI driver teaming
messages
This section provides explanations of the error messages for the Novell NetWare or
IntraNetWare computer ODI driver, and suggested actions to resolve each problem.
Table 14. NetWare driver messages for the Ethernet controller.
Message Description
Couldn’t allocate resources. Explanation: An unknown error has occurred when trying to allocate needed
resources for the AFT Module.
Action:
• Check the computer configuration. If the problem persists, contact your
network administrator.
• Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, run the diagnostic programs.
AFT group for primary adapter in
slot
nnn already exists.
Explanation: An attempt was made to rebind an adapter already in an AFT
group.
Action: Check the AFT slot numbers for existing AFT teams. If the problem
persists, contact your network administrator
Error locating device control table
(DCT) addresses in internal table.
Make sure that you have loaded
LAN drivers after loading AFT.NLM. Explanation: The bind command was entered prior to loading the device driver.
The device driver must be loaded after loading AFT.NLM, but before any bind
command can be issued.
Action: Load the driver for the supported adapter and try loading the AFT
module again. If the problem persists, contact your network administrator.
Insufficient number of arguments
specified. Explanation: The appropriate or expected number of parameters was not
entered in a command.
Action: Check the parameters required for the given command. If the problem
persists, contact your network administrator.
Duplicate slot numbers detected. Explanation: An attempt has been made to bind the same slot number more
than once.
Action: Check the slot numbers entered during the bind. Adapter slot numbers
must be valid and unique. If the problem persists, contact your network
administrator.
’ xxx’ is not supported for AFT team. Explanation: A bind command has been issued for adapters not supported by
AFT.NLM.
Action: Make sure that you attempt to bind only adapters supported by
AFT.NLM.
Primary and Secondary adapters
do not match. AFT group is not
created. Explanation: A bind command was entered for an adapter team that is a
combination of computer and client adapters. An AFT team must be a grouping of
the same classification of adapter.
Action: Verify that all the adapters bound in a team are of the same
classification.
Requested number of Secondary
cards are not found. Explanation: The number of adapters specified in the bind command could not
be located.
Action: Verify the numbers and slot locations of the adapters to be bound. If the
problem persists, contact your network administrator.