IBM InfoPrint 6700 Series, Руководство пользователя

Страница: 206 / 384

206
Chapter 3
Emulation Submenus
Buffer Print
(From page 167, page 170, page 173, page 174.)
•
Disable . The printer will print normally.
•
Enable . The printer prints the EBCDIC data and control codes received
from the host as hex values.
NOTE: Use of this parameter may alter print attributes set by the host
computer. A power cycle may be required after changing Buffer Print
from enable to disable.
The factory default is Disable.
Buffer Reprint
(From page 167, page 173.) This option is valid only when the printer is
printing in Coax SCS mode. When the ENTER key is pressed, “Buffer Reprint
Enabled” displays and an Intervention Required status is sent to the host.
Pressing ENTER again cancels the Buffer Reprint function and displays
“Buffer Reprint Disabled” on the LCD.
Cancel IGP/DCU
(From page 168, page 170.)
•
Enable . Cancels all buffers when a job is put on hold from the host or
when the CANCEL key is pressed.
•
Disable . Does not cancel any internal buffer in the printer when a job is
put on hold from the host, or when the CANCEL key is pressed.
The factory default is Enable.
Change Case
(From page 168, page 180.) Specifies the font as Mono or Dual Case. This
option is available only in Coax non-SCS mode. The host will be notified of
the change when the printer is put online. Mono Case prints the same as Dual
Case if the character set is one of the following “right to left” sets: Katak,
Hebrew, Old Hebrew, and Farsi.
SCS (Systems Network Architecture Character String) Mode is controlled by
the host computer.
The options are Dual Case (the factory default) and Mono Case.