IBM HS40 - BladeCenter - 8839, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 57 / 172

The following illustration shows how to install the additional microprocessors on the
processor board.
Microprocessor-locking lever
Microprocessor
Microprocessor-
heat-sink filler
Heat sink
Heat-sink-retention
mechanism
Complete the following steps to install an additional microprocessor:
1. Review the safety information beginning on page 109 and “Installation
guidelines” on page 33.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing the blade server from
the BladeCenter unit” on page 39 for instructions.
3. Carefully lay the blade server on a flat, nonconductive surface.
4. Open the blade server cover (see “Opening the blade server cover” on page
40 for instructions) and lift it off the blade server.
5. Lift and remove the air baffle covering the microprocessors.
6. Locate the microprocessor socket on the processor board. (See “Processor
board components” on page 35 for numbering order of processors.)
Note: Processors must be installed in order, starting with microprocessor 1,
then microprocessors 2, 3, and 4.
7. Using a #2 screwdriver, loosen the captive screw on the heat-sink retention
mechanism, and rotate the mechanism up.
8. Remove the microprocessor heat-sink filler.
9. Install the microprocessor:
a. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if one is present.
b. Touch the static-protective package containing the new microprocessor to
any unpainted metal surface on the BladeCenter chassis or any unpainted
surface on any other grounded rack component; then, remove the
microprocessor from the package.
Attention: Do not use any tools or sharp objects to lift the locking lever
on the microprocessor socket. Failure to do so might result in permanent
damage to the processor board.
Chapter 4. Installing options
47