IBM eserver Cluster 1350, Инструкция по установке и обслуживанию

Страница: 38 / 122

Replacing a defective cable in a harness
If a cable in a harness is defective, complete the following steps to replace the
cable:
1. Disconnect both ends of the defective cable from their ports. Do not remove any
other connectors from their ports.
2. If possible, remove the cable from the harness. Otherwise, use a pair of wire
cutters to cut off the connectors at both ends of the defective cable. This
prevents someone from mistakenly reconnecting the cable, thinking that it has
inadvertently been left unconnected.
3. Install a single cable between the two empty ports. Use a wire tie to attach the
cable to the harness that contains the defective cable. This identifies the
replacement cable as belonging to this harness.
4. Label the replacement cable so it is clearly identified as a replacement.
22
IBM
Eserver
Cluster 1350 Installation and Service Guide