IBM eserver Cluster 1350, Инструкция по установке и обслуживанию

Страница: 87 / 122

Chapter 17. Removing and replacing the Power Distribution
Unit
The Power Distribution Unit (PDU) provides AC power within the cabinet. The PDUs
are mounted sideways beside the regular rack space. Two types of PDUs are used:
v Rack PDUs
v
Front-end PDUs
Rack PDUs provide power to components within a cabinet, while front-end PDUs
provide the connection to the external power source and distribute the power
among the rack PDUs. A rack PDU can also be directly connected to the external
power source to eliminate the need for the front-end PDU. Up to four front-end
PDUs can be placed in each cabinet and up to twelve rack PDUs.
To remove the Power Distribution Units, perform the following steps:
1. Shut down all devices.
2. Remove the side cover on the side of the rack that the failing PDU is located
on.
3. Turn off each rack PDU using the breaker switch.
4. Unplug each rack PDU from the front-end PDU or customer supplied power
source.
5. If present, unplug the front-end PDU from the customer supplied power source.
6. Remove the four screws holding the plate on which the PDUs are mounted.
7. Turn the plate over to access the screws that hold the rack PDUs and the
front-end PDU (if present) on the plate.
8. Remove the screws holding the failing component to the plate.
9. Replace the failing component (front-end PDU or rack PDU) and reverse the
steps shown above to reinstall the PDUs.
© Copyright IBM Corp. 2004
71