IBM eserver Cluster 1350, Инструкция по установке и обслуживанию

Страница: 96 / 122

When the modules are loaded, the order ends up in such a way that the driver for
the Qlogic FC controller gets loaded before the driver for the Adaptec SCSI
Controller. This causes the probing for the devices to occur such that the Fabric
gets assigned sda , sdb , and so on followed by the local SCSI disks. Make the
following modifications to make sure that the SCSI module is loaded before the
Fibre module. This will validate that the probing and naming assigns the sda device
to the first local disk.
1. First, modify the /etc/modules.conf file by adding the line, options scsi_mod
max_scsi_luns=128 to the end of modules.conf . Also remove unnecessary
information and reorder the way the modules are loaded. An example of an
edited file is as follows:
Original modules.conf :
alias eth0 e1000
alias scsi_hostadapter qla2x00
alias scsi_hostadapter1 aic7xxx
alias scsi_hostadapter2 ips
alias parport_lowlevel parport_pc
alias scsi_hostadapter2 qla2x00
alias usb-controller usb-ohci
alias scsi_hostadapter4 aic7xxx
Edited modules.conf :
alias eth0 e1000
alias scsi_hostadapter aic7xxx
alias scsi_hostadapter1 ips
alias eth1 e1000 alias eth1 e1000
alias parport_lowlevel parport_pc
alias scsi_hostadapter3 aic7xxx
options scsi_mod max_scsi_luns=128
2. Next, rebuild the two initrd images:
mkinitrd initrd-2.4.2-2.img 2.4.2-2 -f
mkinitrd
initrd-2.4.2-2smp.img 2.4.2-2smp -f
3. Reboot the node.
KVM
GUI does not appear on first node
If the GUI display does not appear on the first node of the C2T chain, use the text
mode.
2x8 Switch powers on with console port B
To remedy this go into the menu settings and change from cooperative to
preemptive mode, reselect port 2 and console A will appear. When working properly
do a Snapshot to save the setting.
Cluster port 1 reboots
The cluster Port 1 may reboot on power up, and either boots up in text mode
blinking every 5 seconds or boots up with a white screen. There are two methods to
remedy this situation:
1. Manually select the other ports in the C2T string, then reselect node 1.
2. Unplug the server connections from the port, reattach them in order, and re-plug
in the server.
Subsequent KVMs unresponsive
Make sure the KVM switch that was added is in default settings mode.
80
IBM
Eserver
Cluster 1350 Installation and Service Guide