IBM eserver Cluster 1350, Инструкция по установке и обслуживанию

Страница: 21 / 122

v
Console
v KVM switch
v
10/100 Mb Ethernet switch
v
1 Gb Ethernet switch
v
SMC mini-GBIC expansion module
v
Terminal server
v High-speed Myrinet switch
v
Myrinet cluster expansion card
v High-speed Cisco switch
v
Power management module
v Power distribution unit (PDU)
Cluster nodes
A cluster must contain at least four cluster nodes. The cluster nodes perform the
computational tasks in the cluster. Cluster nodes are also known as compute
nodes.
The cluster nodes are a combination of the following components:
v
Eserver
®
325
v
xSeries 335
v xSeries 345
v
Eserver
BladeCenter
™
unit populated with HS20 blade servers
See Table 1 on page 1 for more information about the Linux software versions
supported on cluster nodes.
Management node
Each cluster contains one management node, which provides system management
for all modules in the cluster. The Cluster 1350 management node is typically an
xSeries 345 server running Linux. You can also use an
Eserver
325 server as the
management node in a cluster environment running a 64-bit Linux operating
system.
Storage nodes
The optional storage nodes manage the mass storage. The cluster supports up to
32 storage nodes. The total number of storage and compute nodes cannot exceed
512.
For tasks that do not require large amounts of mass storage, the storage node has
onboard disk storage that is typically sufficient. The storage nodes can be any of
the following servers in the primary cabinet running the Linux operating system:
v
Eserver
325 - a 1 U storage unit
v
xSeries335 - a 1 U storage unit
v xSeries 345 - a 2 U storage unit
v
xSeries 360 - a 3 U storage unit
v
Eserver
BladeCenter unit populated with HS20 blade servers
Chapter 1. System overview
5