IBM DCAS-32160 - Ultrastar 2.1 GB Hard Drive, Технические характеристики

Страница: 201 / 232

Queue Full Status is returned
Busy Status is returned
If an active I/O process does exist when the Target receives a new command, then the Target determines
how the new command should be handled based on the following rules:
Check Condition Status is returned with Sense Key set to Aborted Command for an Overlapped Com-
mands Attempted error if:
−
See 11.1.3, “Incorrect Initiator Connection” on page 186
the command is permitted to execute if
−
the command is an Inquiry or Request Sense command
Check Condition Status is returned with Sense Key set to Logical Unit Not Ready if:
−
the start-up operation or format operation is an active process.
the command is permitted to execute if
−
the conditions to execute concurrently are met. (See 11.5, “Concurrent I/O Process” on page 195)
the command is added to the command queue for an I_T_L nexus if:
−
no Queue Tag message was received during the connection which
established the I/O process,and
−
disconnection is allowed for the current I/O process, and
−
there is no queued I/O process or active I/O process corresponding to the
I_T_L nexus for the current I/O process, and
−
the command is not linked to a previous command.
the command is added to the command queue for an I_T_L_Q nexus if:
−
a Queue Tag message was received during the connection which
established the I/O process, and
−
Tagged Queuing is enabled(DQue = 0), and
−
an I/O process(either active or queued) exists at the Target for this
Initiator, and
−
disconnection is allowed for the current I/O process, and
−
there is no queued I/O process or active I/O process corresponding to the
I_T_L_Q nexus for the current I/O process, and
−
the command is not linked to a previous command.
Queue Full Status is returned if:
−
the command would otherwise be queued (according to the rules described
above) but the command queue is full and all slots are utilized, or
−
the command would otherwise be queued (according to the rules described
above) but all of the available command queue slots not reserved for use
by another initiator are utilized, or
−
Tagged Queuing is enabled(DQue = 0) and a Format Unit command was
previously queued but has not yet begun execution, or
−
Tagged Queuing is enabled(DQue = 0) and a Start Unit command was
previously queued but has not yet begun execution.
Busy Status is returned if:
−
Tagged Queuing is disabled(DQue = 1) and a Format Unit command was
previously queued but has not yet begun execution, or
−
Tagged Queuing is disabled(DQue = 1) and a Start Unit command was
previously queued but has not yet begun execution, or
Additional Information
187