IBM 9306 001, Руководство по техническому обслуживанию аппаратной части

Страница: 23 / 122

Sliding Rails
This procedure is for single latch sliding rails and dual
latch sliding rails.
For single latch sliding rails, the right rail is the one that
has the front latch. The left rail does not have a front
latch.
For dual latch sliding rails, the right rail is the one that has
the rear latch. The left rail does not have a rear latch.
To remove the sliding rails:
1. Power-off the rack.
2. Remove the sliding tray that is attached to the sliding
rails that you want to remove. See “Sliding Trays” on
page 13.
3. Use a 3/32-inch allen wrench to remove the four
screws that secure each of the sliding rails to the rack
cabinet.
Note
You will need to adjust the position of the sliding
rail in order to line up the access holes over the
locations of the screws.
Keyboard Tray
To remove the keyboard tray:
1. Power-off the rack.
2. Disconnect the keyboard and mouse cables from the
keyboard and mouse extension cables.
3. Remove the keyboard and mouse from the keyboard
tray.
4. Pull the keyboard tray straight out of the rack cabinet.
Type 9306 Models 4QS, 4QX, 9QS, 9QX, 9TS, 9TX
15