IBM 9306 001, Руководство по техническому обслуживанию аппаратной части

Страница: 21 / 122

Sliding Trays
Models 4QS and 4QX come with either single latch slide
rails or dual latch slide rails. Single latch slide rails have a
front latch release on the right rail only. Dual latch slide
rails have a front latch release on both rails. The slide rail
FRU number for the 24-inch rack replaces the single latch
slide rail with the dual latch slide rail.
Note
If a server is installed on a tray being removed, first
remove the server.
Single Latch Rail Tray:
To remove a sliding tray with single latch rails:
1. Power-off the rack.
2. Open the rear door of the rack cabinet and remove
the pin
.1/
that secures the sliding tray to the cable
management arm
3. Loosen the thumbscrews
.2/
on the sliding tray and
fully extend the sliding tray.
4. Use a 3/32-inch allen wrench to remove the five
screws
.3/
from the left side of the sliding tray.
5. Lift the rear locking tab
.4/
and push the sliding tray
approximately two inches into the cabinet.
6. Release the forward locking tab
.5/
. Then, while
holding the sliding tray in place, use your other hand
to grasp the outside sliding rail
.6/
and push it into
the rack cabinet until it disconnects from the sliding
tray.
Type 9306 Models 4QS, 4QX, 9QS, 9QX, 9TS, 9TX
13