IBM 9306 001, Руководство по техническому обслуживанию аппаратной части

Страница: 22 / 122

Dual Latch Rail Tray:
To remove a sliding tray with dual latch rails:
1. Power-off the rack.
2. Open the rear door of the rack cabinet and remove
the pin
.1/
that secures the sliding tray to the cable
management arm
3. Loosen the thumbscrews
.2/
on the sliding tray and
fully extend the sliding tray.
4. Push in on the spring of the right rear locking tab
.3/
and push the sliding tray approximately two inches
into the cabinet.
5. Release both left and right forward locking tabs
.4/
.
Then, while holding the sliding tray in place, push
both left and right outside sliding rails
.5/
into the
rack cabinet until it disconnects from the sliding tray.
Note
Left side view for
.4/
and
.5/
are not shown.
14
IBM PC Server/Netfinity Racks HMM