IBM 7979B1U, Руководство пользователя

Страница: 97 / 144

Attention: In a dc power environment, only trained service personnel other
than IBM service technicians are authorized to connect or disconnect power to
the dc power supply. See the documentation that comes with each dc power
supply.
3. Remove the cover (see “Removing the cover” on page 31).
4. Follow the instructions that come with the drive to set any jumpers or switches.
Alignment pins
Drive retention clip
5. Attach the drive retention clip to the side of the drive.
6. Slide the drive into the CD/DVD drive bay until the drive clicks into place.
If you have other optional devices to install or remove, do so now. Otherwise, go to
“Completing the installation.”
Completing the installation
To complete the installation, complete the following steps:
1. If you removed the PCI riser-card assembly, replace the riser-card assembly
(see “Installing the riser-card assembly” on page 33).
2. If you removed any air baffles, replace the air baffles (see “Installing the
microprocessor air baffle” on page 35 and “Installing the DIMM air baffle” on
page 37).
3. If you removed the server cover, place the cover-release latch in the open (up)
position. Insert the bottom tabs of the top cover into the matching slots in the
server chassis. Press down on the cover-release latch to lock the cover in
place.
Cover-release
latch
4. Install the server in a rack. See the Rack Installation Instructions that come with
the server for complete rack installation and removal instructions.
Chapter 2. Installing optional devices
81