IBM 7979B1U, Руководство пользователя

Страница: 64 / 144

v
The server 2.5-inch models support eight 2.5-inch hot-swap hard disk drives
installed on Ultra-Slim hard disk drive trays for 2.5-inch drives. For a list of
supported 2.5-inch hard disk drives, see http://www.ibm.com/servers/eserver/
serverproven/compat/us/.
v
All hot-swap drives in the server should have the same throughput speed rating.
Mixing hard disk drives with different speed ratings will cause all drives to
operate at the lower throughput speed.
v The ID that is assigned to each bay is printed on the front of the server.
The following illustrations show how to install a hot-swap hard disk drive.
3.5-inch drives
Filler panel
Hard disk drive
Tray handle
2.5-inch drives
To install a drive in a hot-swap bay, complete the following steps.
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each bay.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 28.
2. Remove the filler panel from one of the empty hot-swap bays.
48
System x3650 Type 7979: User’s Guide